Making the dog house parts

Following these steps will help you have all the panels and sizes ready, take a look at the dog house measurements when in doubt on how to cut or attach the panels.

1. Cut two 40 x 40 in pieces of plywood for the front and back panels. Follow the picture on how to cut them properly. Including the roof angles. 
2. The door opening must be cut with a jig saw, for it to be easier start by drilling a hole at the door bottom corner, make sure it's big enough for the saw blade to fit, and then cut away.
   The door opening on this is 16W x 18H you can change this depending on your needs.
3. Cut the side panels to the right size (42 ½ x 23 in)
4. Cut the internal divider (36 ¼ x 42 ½ in). Using the front panel as the sample, lay on top of the wall divider and trace the size of the door opening on it, so you make sure the door openings are the same. Cut the door opening on the divider 2 in away from the back wall and so it's flush with the divider floor.

Assembling the dog house